Material section and requirements of hydraulic cylinder barrel

Material section and requirements of hydraulic cylinder barrel

The required cylinder is the key component of the hydraulic cylinder, and sometimes the direct acting component of the hydraulic cylinder (when fixing the piston rod or plunger);The cylinder body, end cover and piston (plunger) constitute a sealing chamber for holding pressure oil and acting as a driving load;Therefore, the strength, stiffness and sealing requirements of the cylinder are as follows:

(1) The barrel should have sufficient strength to prevent permanent deformation under long-term rated operating pressure and short-term dynamic test pressure.

(2) The barrel should have sufficient rigidity to prevent bending caused by lateral force imposed by the piston and reacting force during installation.

(3) Reliable seal: The grade of dimensional tolerance and accuracy of geometric tolerance of cylinder inner surface, piston seal and supporting ring should be designed rationally to ensure reliable seal and reduce wear.

(4) The cylinder barrel to be welded should have good weldability to avoid cracking or excessive deformation after welding of flange, cylinder bottom or joint.

The above requirements should be guaranteed by proper selection of barrel material and rational process of manufacturing.

Material selection of hydraulic cylinder barrel:

(1) Generally, the annealed cold-drawn or hot-rolled seamless steel tube is used as the workblank of cylinder barrel. The semi-finished product with honed or accurately machined inner hole is available on the market, which may be cut into seamless steel tubes of the required length. Optional materials include 20#, 35#, 45# steel and 27SiMn alloy steel.

(2) Hydraulic cylinder barrel with operating temperature below -500C must be made of 35# or 45# steel and treated by thermal refining.

(3) The barrel welded with cylinder cover or flange should be made of 35# steel and treated by thermal refining after pre-machining, while the cylinder not welded with other parts should be made of hardened and tempered 45# steel.

Anbao Hydraulic is a professional manufacturer of hydraulic cylinder with over 23 years experience in china , we have exporte to more than 60 countries in the world,honed tube ,chrome rod,chrome bar ,hollow chrome bar are hot selling products in our company ,any problems pls send us inquiry ,Wish Anbao will be your next choice.

Shanghai Anbao Hydraulic

Att:Mr.Bruce

phone: +86-136 81801718

web: https://anbaohydraulic.com/

Email: inquiry@ab-steel.com